The following guide is for configuring Cisco SPA 112/122 with your VoIPtalk account.

You will need:

• The VoIPtalk ID – In case you don’t know it, you can find it by logging to your VoIPtalk control panel at voiptalk.org
• The VoIPtalk password –  Go to the bottom of the page in case you need assistance with it.
• The Proxy /SIP Server – “voiptalk.org”
• The Proxy port – “5060”
• The Outbound proxy server – “nat.voiptalk.org”
• The Outbound proxy port – “5065”

1-) Connect the adapter via the internet port to your router, using an Ethernet cable. 

2-) Connect the adapter via one of the phone port to an analogue phone.

3-) Once the adapter has been powered on, lift the receiver and dial **** for the configuration menu.

4-) When "Configuration menu" is heard, dial 110# to hear the IP address. Note it down.

5-) On a computer which is connected to the same subnet as the adapter, open a web browser and type the full IP address (including the dots) into the address bar.

6-) On the login screen that will appear, enter "admin" (case sensitive) as both username and password.

7) Once you have logged in, you will see a screen like the one below:

8) From the menu select the "Voice" Tab, then "Line 1" from the left side 

menu. The main configuration settings will appear.

9) Enter the details as follows:

Proxy and Registration:

Proxy: voiptalk.org

Outbound Proxy: nat.voiptalk.org:5065

Use Outbound proxy: Yes

Subscriber Information: 

Display Name: Your VoIPtalk Id

Password: your VoIPtalk account password

User Id: your VoIPtalk ID

10-) If configured correctly, the configuration should look like this:

Click submit to allow the adapter to save and reboot itself.

To check if the Cisco is registered, dial 902 from the handset. if you hear a congratulation message, then the registration was successful.